Pipe repair and leak response
For dampness or a suspected pipe fault, we first record visible signs, affected lines and urgency. We then determine whether a local repair is possible or specialist leak detection and drying are required.
Typical tasks
What this service may include.
- Visual inspection and fault narrowing
- Repair of accessible pipe sections
- Replacement of damaged joints
- Leak check after repair
The exact scope depends on the existing system, access, technical requirements and the required trade authorisation. These points are checked before an order is accepted.
Our process
How the work is prepared and completed.
- 01
Narrow down the fault
Dampness, pipe route, shutoffs and potential consequential damage are assessed.
- 02
Agree the repair route
Access, replacement parts and any specialist contractors are clarified before work starts.
- 03
Repair and verify
The accessible fault is repaired, followed by a leak check.
What we check
- Investigate the cause rather than hiding the symptom
- Limit openings to what is reasonably required
- Use connection methods suited to the existing material
- Identify any drying or follow-up work required
Next service
Bathroom and kitchen plumbing
Direct contact
Planning work in this area?
Tell us briefly about your project. We will clarify the practical next steps with you.